Customize Parameters
- CUSTOMIZE SEAT BELT WARNING SYSTEM
NOTE:
The following items can be customized.
CAUTION:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).
- Customizing with the SSM4
- Connect the SSM4 to the DLC3.
- Turn the ignition switch to ON.
- Turn the SSM4 on.
- Enter the following menus: [Each System]/[Combination Meter]/[Customize]
- Select the setting by referring to the table below.
WARNING DISPLAY REFERENCE
| Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Driver Side Seatbelt Warning Buzzer | ON | Function to sound the driver seat belt warning buzzer | ON/OFF | Combination meter assembly |
| Front Passenger Side Seatbelt Warning Buzzer | ON | Function to sound the front passenger seat belt warning buzzer | ON/OFF |
NOTE:
This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.