Inspection steps

1. Using SSM4, perform an [Active Test] by following the display. (Refer to Data monitor/active test )

   Criteria: The [Active Test] can be performed properly.

   POWER WINDOW ACTIVE TEST DESCRIPTION
   
   

   Item name	Drive
   [Power Window Motor Driver side]	UP/DOWN

   RESULT REFERENCE
   
   

   Item	Go to
   NG	A
   OK	B

   B: Replacement of the power window regulator master switch ASSY (driver's seat) (Refer to Power window regulator master switch ASSY )

   A

2. Inspection of the wire harness and connector (power window regulator master switch ASSY - battery and chassis ground)
   1. Disconnect the connector E8 of power window regulator master switch ASSY.
   2. Measure the voltage between the terminals.
      VOLTAGE SPECIFICATION
      
      

      Inspection terminals (Terminal symbol)	Inspection conditions	Standard value
      E8-12 (+B) - chassis ground	Always	11 to 14 V

   3. Measure the resistance between the terminals.
   RESISTANCE SPECIFICATION
   
   

   Inspection terminals (Terminal symbol)	Inspection conditions	Standard value
   E8-5 (GND) - chassis ground	Always	Less than 1 Ω

   Fig 1: Identifying Power Window Regulator Master Switch Assy Connector Terminals

   Courtesy of SUBARU OF AMERICA, INC.

   NG: Repair or replacement of wiring harness or connector

   OK

1. Disconnect the connector E8 of power window regulator master switch ASSY.
2. Disconnect the connector E5 of the power window regulator motor ASSY LH (driver's seat).
3. Measure the resistance between the terminals.

NG: Repair or replacement of wiring harness or connector

OK

1. Replace with the new or normal power window regulator master switch ASSY, and verify normal operation. (Refer to Removal )

B: Replacement of the power window regulator motor ASSY RH (Refer to Removal )

A: Complete (switch malfunction)