LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging system (FA20) >> Checking/clearing diagnostic codes

Checking/clearing diagnostic codes

  1. Checking diagnostic codes (reading with SSM4)
    1. With the ignition turned to IG OFF, connect the SSM4 to the DLC3.
    2. Turn IG to ON, and turn on the SSM4.
    3. Follow the SSM4 display and select [Inspection of BRZ] →[Each System] →[Engine Control System] →[DTC] to check the diagnostic codes.
  2. Clearing diagnostic code records (Cleared by the SSM4)
    1. With the ignition turned to IG OFF, connect the SSM4 to the DLC3.
    2. Turn IG to ON, and turn on the SSM4.
    3. Follow the SSM4 display and select [Inspection of BRZ] →[Each System] →[Engine Control System] →[Clear Memory] to delete the diagnostic codes.
      CAUTION:
      • If deletion is not possible, retry it after turning the ignition to IG OFF and then on.
      • Do not use the SSM4 to delete diagnostic codes until the cause of the trouble has been identified.
scientia non olet · About LEMON Manuals