LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Side Airbag Sensor >> Installation

Side Airbag Sensor: Installation

  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • The side airbag sensor, sensor bracket, or connector are damaged.
    • Side airbag module has been activated.
  2. Install the side airbag sensor.
    CAUTION: Do not reuse the bolt and nut.
    Always replace with the specified new bolts and nuts.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  3. Install the seat belt retractor.

    Tightening torque: 

    Front seat belt: < Ref. to  FRONT SEAT BELT  , COMPONENT, General Description. > 

  4. Install the cover side sill - front INN, cover side sill - rear INN, and trim panel - center pillar LWR.
  5. Connect the battery ground terminal. < Ref. to BATTERY , NOTE, Note. >
    NOTE: For models other than STI model, connect the ground terminal to battery sensor.
scientia non olet · About LEMON Manuals