Curtain Airbag Module: Installation

CAUTION:

Refer to "CAUTION" of "General Description" before handling the airbag system components. < Ref. to CAUTION , General Description. >
When installing the curtain airbag module, install a specified part at specified place.
Be careful not to damage the curtain airbag module during installation.
Never open the curtain airbag module before activation. Never reuse the deployed curtain airbag module.
Make sure that there are no foreign matter on airbag module.
When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.
For installation of the stereo camera cover, refer to "INSTALLATION", "Stereo Camera" in the "EyeSight" section and observe the precautions for installation. < Ref. to INSTALLATION , Stereo Camera. >

Before installation, inspect the following items and replace any faulty part with a new one.
- Airbag cover is scratched or torn.
- Harness and/or connector is cracked, deformed or open.
- Harness wire is exposed.
- Mounting bracket and securing clip are cracked or deformed.
Install the curtain airbag module.
CAUTION:
- Be sure to insert the connector in until it is locked.
- Press in the push lock securely. Then pull it gently to make sure that it is locked.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the trim panel - roof assembly. < Ref. to INSTALLATION , Roof Trim. >
Connect the battery ground terminal. < Ref. to BATTERY , NOTE, Note. >
NOTE: For models other than STI model, connect the ground terminal to battery sensor.