Stop Light Switch: Installation
- Install the stop light switch.
- Align the groove of clip with the cutout portion of stop light switch push rod.
- While pulling up the brake pedal (a) toward you, let the push rod of the stop light switch (b) stroke, and insert it until it reaches the stopper (c).
- Install the stop light switch by turning it clockwise.
- Connect the connector.
- Install the knee airbag module.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the cover assembly - instrument panel LWR driver.
- Connect the battery ground terminal. < Ref. to
BATTERY
, NOTE, Note. >NOTE: For models other than STI model, connect the ground terminal to battery sensor.