CVT Model

CAUTION: Before performing service on the airbag module, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" section. < Ref. to CAUTION , General Description. >

Install the brake pedal assembly.
CAUTION:
- Apply grease to the snap pin to prevent the operating rod from wear.
- Replace the clevis pin with new parts, and apply thin coat of NIGTIGHT LYW No. 2 grease to the clevis pin.
Tightening torque:

Brake pedal: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the column assembly - steering. < Ref. to INSTALLATION , Steering Column. >
Install the knee airbag module.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the cover assembly - instrument panel LWR driver.
Connect the battery ground terminal. < Ref. to BATTERY , NOTE, Note. >
NOTE: For models other than STI model, connect the ground terminal to battery sensor.
Check that the brake light operate properly.
Check the brake pedal after installation. < Ref. to INSPECTION , Brake Pedal. >