LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Multi-function Display (MFD) >> Installation >> Multi Function Display

Multi Function Display

CAUTION:
  • Make sure the electrical connector is connected securely.
  • Make sure that the multi-function display operates normally.
  • After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.
  • When the multi-function display has been replaced, perform the following operations.
    • Be sure to reset the ODO fuel economy value of the multi-function display (MFD). < Ref. to ODO FUEL ECONOMY VALUE RESET , OPERATION, Multi-function Display (MFD) System. >
    • Be sure to correction the lifetime fuel economy value of the multi-function display (MFD). < Ref. to DIAGNOSTIC MODE , OPERATION, Multi-function Display (MFD) System. >
  1. Install the multi-function display.
  2. Install the cover center UPR.
  3. Install the center grille assembly.
  4. Connect the battery ground terminal. < Ref. to BATTERY , NOTE, Note. >
    NOTE: For models other than STI model, connect the ground terminal to battery sensor.
scientia non olet · About LEMON Manuals