Demonstration Screen Display
The demonstration mode screen can be displayed according to the following procedure.
CAUTION:
- While the ignition switch is OFF (ACC OFF), perform the steps described in 2) through 4) below within 10 seconds.
- To avoid battery discharge, perform the operation under the following condition.
- Perform the operation while the battery is being charged.
- While performing the operation and displaying the demonstration mode, do not operate any electrical parts.
- Perform the steps described in (2) through (5) within 10 seconds.
| (1) | Sit in the driver's seat and close the door. |
| (2) | Open the drivers door, and within 5 seconds, press the MFD (ENTER) switch three times. |
| (3) | Close the drivers door, and press the MFD (ENTER) switch three times. |
| (4) | Open the drivers door, and press the MFD (ENTER) switch three times. |
| (5) | Close the drivers door, and press the MFD (ENTER) switch three times. |
| (6) | Go to "DEMONSTRATION SCREEN DISPLAY ". |
NOTE:
The demonstration display will be cancelled in any of the following conditions.
- When 60 minutes elapsed since the demonstration mode started
- When the ignition switch is turned to ON
- When the MFD (ENTER) switch is turned to ON for two seconds
- When the battery voltage is low