LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft System - Security And Locks >> Security System >> Inspection >> Check Security System Condition Memory

Check Security System Condition Memory

  1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.
  2. Close all doors or trunk lid.
  3. Open the front hood.
  4. Press the LOCK button of the keyless transmitter or access key.
    NOTE: Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals.

    If the 30 second monitoring lag has been set, wait for 30 seconds.

  5. Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note. >
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  6. Connect the ground cable to battery. < Ref. to BATTERY , NOTE, Note. >
    NOTE: For models other than STI model, connect the ground terminal to battery sensor.
  7. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit.
scientia non olet · About LEMON Manuals