LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft System - Security And Locks >> Impact Sensor >> Operation >> Impact Sensor Setting Using SUBARU Select Monitor

Impact Sensor Setting Using SUBARU Select Monitor

  1. Make an impact monitor setting.
    1. Connect the Subaru Select Monitor to data link connector.
      NOTE: For detailed operation procedures, refer to "Application help".
    2. Turn the ignition switch to ON.
    3. On «Start» display, select «Diagnosis».
    4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
    5. On «Main Menu» display, select «Each System».
    6. On «Select System» display, select «Integ. Unit Mode» and select «Enter».
    7. On «Select Function» display, select «Customize».
    8. Make an impact monitor setting.
      • When installing: ON
      • When removing: OFF
    9. Make an impact monitor ON/OFF setting.
      • When installing: ON
      • When removing: OFF
    10. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
scientia non olet · About LEMON Manuals