LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> Outback 2.5i Limited >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats >> Seat Heater System >> Installation >> Seat Heater Module - Front

Seat Heater Module - Front

  1. Affix the seat heater module - front to the pad assembly.
    CAUTION:
    • If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.
    • When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring.
    • When removing or replacing the seat cover, perform "Occupant Detection System Inspection" after installing the seat to check if the occupant detection system operates normally. < Ref. to SEAT , PRE-DELIVERY INSPECTION (PDI) PROCEDURE, Pre-delivery Inspection. >
    • If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part.
    • If the seat heater module is reused, remove the polyurethane section from the reverse side completely.

    Double-sided tape: 

    NITTO DENKO 501L or equivalent 

  2. Assemble the front seat. < Ref. to ASSEMBLY , Front Seat. >
  3. Install the front seat.

    Tightening torque: 

    53 N.m (5.4 kgf-m, 39.1 ft-lb) 

scientia non olet · About LEMON Manuals