Check Roll Connector

CAUTION: If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U). >

Remove the roll connector. < Ref. to REMOVAL , Roll Connector. >

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Fig 1: Measuring Resistance Between Roll Connector

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Standard
A1 - C9	Always	Less than 1 Ω

Replace the roll connector if the inspection result is not within the standard value.