Rear Height Sensor: Inspection
WARNING: This page is about a different car, the 2016 Subaru Impreza and 2016 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
- Connect three dry cell batteries (1.5 V) in series.NOTE:
- Use new dry-cell batteries.
- Using a circuit tester, check that the initial voltage of each dry-cell battery is 1.6 V or more. And also check that the voltage of three batteries in series is between 4.8 V and 5.2 V.
- For power supply, 5 V DC constant voltage power source can also be used.
- Connect the cell battery positive terminal to the connector terminal No. 3, and the cell battery negative terminal to the connector terminal No. 1.
- With voltage applied, check the voltage between terminals when the sensor link is moved slowly up and down.
Preparation tool:
Circuit tester
Terminal No. Inspection conditions Standard 2 (+) - 1 (-) Move the link within the operation range. 0.5 - 4.1 V - Replace the sensor assembly - headlight beam leveler if the inspection result is not within the standard value.