LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation/Driver Info >> Steering Switch >> Installation

Steering Switch: Installation

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM > General Description > CAUTION .
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) >  ADJUSTMENT  .
  1. Align the center position of the steering roll connector. Ref. to AIRBAG SYSTEM > Roll Connector >  ADJUSTMENT  .
  2. Install each part in the reverse order of removal.
    NOTE: Align the alignment marks on the steering wheel and the column assembly - steering.

    Tightening torque: 

    Steering wheel: 39 N.m (3.98 kgf-m, 28.8 ft-lb)

    Clearance: 

    Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)

scientia non olet · About LEMON Manuals