Master Cylinder: Installation

Install the master cylinder to the body, and connect the clutch pipe and the tank hose.
Tightening torque:

T1: 15 N.m (1.5 kgf-m, 11.1 ft-lb)

T2: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Identifying Clutch Pipe And Tank Hose Bolts
Courtesy of SUBARU OF AMERICA, INC.
Connect the push rod of the master cylinder, and install the clevis pin and snap pin.
CAUTION: Always use a new clevis pin.

NOTE: Apply grease to the clevis pin.

Fig 2: Identifying Clevis Pin, Snap Pin, Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Install the knee airbag module. < Ref. to INSTALLATION , Knee Airbag Module. >
Fill the recommended brake fluid. < Ref. to CLUTCH FLUID . >
After bleeding air from the clutch system, ensure that the clutch operates properly. < Ref. to CLUTCH FLUID AIR BLEEDING . >
Install the cover assembly - instrument panel LWR driver. < Ref. to INSTALLATION , Instrument Panel Lower Cover. >
Install the air intake boot. < Ref. to INSTALLATION , Air Intake Boot. >
Connect the battery ground terminal.