Roll Connector: Installation

WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek and 2015 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the steering wheel and steering angle sensor are removed, perform "VDC SENSOR MIDPOINT SETTING MODE " of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U).>

Before attaching a new roll connector, apply a thin coat of grease contained in the connector onto the areas shown by the arrows.

Fig 1: Locating Coat Of Grease Applying Area Connector
Courtesy of SUBARU OF AMERICA, INC.
Install each part in the reverse order of removal.
Before installing steering wheel, be sure to adjust the direction of roll connector with steering. < Ref. to ADJUSTMENT , Roll Connector.>
Tightening torque:

Steering wheel: 39 N.m (3.98 kgf-m, 28.8 ft-lb)

Clearance:

Cover assembly - column to Steering wheel: 4 - 6 mm (0.16 - 0.24 in)