Knock Sensor: Installation

WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block.
NOTE: The knock sensor should be installed so that the center of the connector is positioned at a 76.5 - 91.5° angle relative to the front of engine.

Tightening torque: 24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Locating Knock Sensor Installation Angle
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector to the knock sensor.

Fig 2: Locating Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the throttle body. < Ref. to INSTALLATION , Throttle Body.>
Install the collector cover.
Connect the battery ground terminal. < Ref. to BATTERY , NOTE, Note.>