Chamber (Fa20): Installation

Chamber assembly installation
1. Install the chamber assembly with the hose clamp.
  Standard value: T=2.0N.m {20kgf.cm} {1.5ft.lbf}
Duct installation
1. Install the duct and chamber assembly as a unit with the two bolts.
  Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
2. Install the duct with the hose clamp.
  Standard value: T=2.0N.m {20kgf.cm} {1.5ft.lbf}
Hose installation
1. Engage the two clamps and install the hose.
2. Insert the hose until the flange at the hose end contacts the grommet.
  
  Fig 1: Installing Hose In Grommet
  Courtesy of SUBARU OF AMERICA, INC.
  
  CAUTION: When inserting the hose end, insert the hose so that the grommet rubber is not engulfed to avoid water leakage.
  
  Fig 2: Locating Grommet Rubber
  Courtesy of SUBARU OF AMERICA, INC.
3. Make sure from the passenger room side that the hose end is inserted properly.
4. Connect the hose and install the hose.