Power Window Regulator Switch Assembly (Installed To The Front Side): Installation
WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
- Installation of power window regulator switch assembly
- Engage the 6 claws and install the power window regulator switch assembly to the front armrest base panel UPR RH.
- Installation of power window regulator switch assembly W/front armrest base panel UPR RH (Refer to ADJUSTMENT )
- Installation of front door trim board SUB-assembly RH
Install the part in the same manner as LH side. (Refer to ADJUSTMENT )
- Installation of door armrest cover RH
Install the part in the same manner as LH side. (Refer to ADJUSTMENT )
- Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
- Settings when removing/installing battery terminals (Refer to SETTING PROCEDURES AT PARTS REPLACEMENT AND REMOVAL/INSTALLATION )