Engine Oil Pressure Switch Assembly (Fa20): Installation

Engine oil pressure switch ASSY installation
1. Degrease the threaded portion of engine oil pressure switch assembly.
2. Apply THREE BOND 1324 to the threaded portion.
  CAUTION: Do not apply THREE BOND 1324 to the oil hole.
  
  Fig 1: Applying Sealer To Engine Oil Pressure Switch Assembly
  Courtesy of SUBARU OF AMERICA, INC.
3. Install the engine oil pressure switch assembly.
  Standard value: T=18N.m {184kgf.cm} {13.3ft.lbf}
  
  CAUTION: Do not start the engine within 1 hour after the assembly.
4. Connect the connector of oil pressure switch.
Installation of air cleaner case SUB-ASSY (Refer to ON-VEHICLE INSPECTION )
Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
Engine oil leakage check (Refer to OIL & OIL FILTER (FA20) )