LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Electrical >> Starter >> Engine Immobilizer System (W/ Entry & Start) >> Engine Immobilizer System (With Entry & Start System) >> DTC Check/Clear

DTC Check/Clear

  1. CHECK FOR Immobilizer DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM3 on.
    4. Enter the following menus: [Keyless access system] →[Collation ECM] →[Diagnostic Code(s) Display]
    5. Check for DTCs.
  2. CHECK FOR ECM DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM3 on.
    4. Enter the following menus: [Engine Control System] →[Diagnostic Code(s) Display]
    5. Check for DTCs.
  3. CLEAR Immobilizer DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM3 on.
    4. Enter the following menus: [Keyless access system] →[Collation ECM] →[Clear Memory]
    5. Clear the DTCs.
  4. CLEAR ECM DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM3 on.
    4. Enter the following menus: [Engine Control System] →[Clear Memory]
    5. Clear the DTCs.
scientia non olet · About LEMON Manuals