LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX STI >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Front Outer Handle >> Removal

Front Outer Handle: Removal

  1. Raise the glass assembly - front door to the top position.
  2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. <Ref. to BATTERY , NOTE, Note.>
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  3. Remove the trim panel - front door. <Ref. to FRONT DOOR , REMOVAL, Door Trim.>
  4. Remove the sealing cover - front door. <Ref. to REMOVAL , Front Sealing Cover.>
  5. Remove the holder of the frame assembly - front door outer.
    Fig 1: Removing Front Door Outer Frame Assembly Holder
    G08319209Courtesy of SUBARU OF AMERICA, INC.
    NOTE:
    • For model with keyless access, disconnect the harness clip and exterior antenna (touch sensor) connector.
    • Using (a) shown in the figure as a supporting point, pry it with a flat tip screwdriver to remove.
    Fig 2: Disconnecting Harness Clip And Exterior Antenna (Touch Sensor) Connector
    G09484638Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the cover - handle front outer.

    Preparation tool: 

    TORX® T30 

    1. Remove the plug at the rear end of the panel assembly - front door.
    2. Loosen the TORX® bolt and remove the cover - handle front outer.
    Fig 3: Removing Front Door Panel Assembly Rear End Plug
    G06653885Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the handle - door outer.
    CAUTION: Do not apply excessive force to remove the handle - door outer from the frame assembly - front door.
    1. Pull the handle - door outer rearward to release engagement of the frame assembly - front door outer.
    2. Pull the handle - door outer towards yourself to remove the handle - door outer.
    Fig 4: Removing Outer Door Handle
    G06653886Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the frame assembly - front door outer.

Preparation tool: 

TORX® T30 

  1. Remove the spacer - door handle outer.
    Fig 5: Locating Outer Door Handle Spacers
    G06653887Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the rod clamp and remove the rod.
  3. Loosen the TORX® bolt and remove the frame assembly - front door outer.
Fig 6: Removing Rod Clamp And Rod
G08319213Courtesy of SUBARU OF AMERICA, INC.