Drive Cycle A
| DTC | Item | Condition |
|---|---|---|
| P0601 | Internal Control Module Memory Checksum Error | Perform the drive cycle A twice. |
| P0604 | Internal Control Module Random Access Memory (RAM) Error | Perform the drive cycle A twice. |
| P062F | Internal Control Module EEPROM Error | Perform the drive cycle A twice. |
| P0712 | Transmission Fluid Temperature Sensor Circuit Low Input | - |
| P0842 | Secondary Oil Pressure Sensor Circuit (Low) | - |
| P0843 | Secondary Oil Pressure Sensor Circuit (High) | - |
| P0890 | AT Self-Shut Relay Diagnosis (Low) | - |
| P0962 | Secondary Solenoid Circuit (Low) | - |
| P0963 | Secondary Solenoid Circuit (High) | - |
| P0966 | Forward & Reverse Solenoid Circuit (Low) | - |
| P0967 | Forward & Reverse Linear Solenoid Circuit (High) | - |
| P160A | Random Access Memory (RAM) Error Perform the drive cycle A | twice. |
| P2530 | Ignition Switch Run Position Circuit | - |
| P2763 | Lock-Up Duty Solenoid Circuit (High) | Perform the drive cycle A, then perform the drive cycle C. |
Diagnostic procedure:
- Start the engine.
- Depress the brake pedal and move the select lever to each range at an interval of five seconds.NOTE: Move the select lever in the following order: "P" → "R" → "N" → "D" → "N" → "R" → "P".