Section 11 (Exhaust System (STI)): Muffler: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.

NOTE:

Use a new gasket and self-locking nut.
After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.

Tightening torque:

10 N.m (1.0 kgf-m, 7.4 ft-lb)

Fig 1: Locating Rear Exhaust Cover Cushion Rubber And Bolts

Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

48 N.m (4.9 kgf-m, 35.4 ft-lb)

Fig 2: Locating Muffler Bolts

Courtesy of SUBARU OF AMERICA, INC.