LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Vehicle Dynamics Control (VDC) System (Service Information)) >> Front ABS Wheel Speed Sensor >> Installation

Front ABS Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be careful not to damage the sensor.
  • Do not apply excessive force to the sensor harness.
  1. Install the front ABS wheel speed sensor.

    Tightening torque: 

    Front ABS wheel speed sensor: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  2. Install the front wheels.

    Tightening torque: 

    Front wheel: 120 N.m (12.2 kgf-m, 88.5 ft-lb) 

  3. Lower the vehicle.
    NOTE: Check if the harness is not pulled and does not come in contact with the suspension or body while operating the steering.
  4. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
scientia non olet · About LEMON Manuals