LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Vehicle Dynamics Control (VDC) System (Service Information)) >> ABS Sequence Control >> Operation >> Abs Sequence Control With SUBARU Select Monitor

Abs Sequence Control With SUBARU Select Monitor

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the event of any trouble, the ABS sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector.
    1. Run the "PC application for Subaru Select Monitor".
    2. On «Main Menu» display, select «Each System Check».
    3. On «System Selection Menu» display, select «Brake Control System».
    4. When «ABS/VDC System» is displayed, select the [OK] button.
    5. From «Work Support», select «ABS Sequence Control Mode».
  2. Follow the procedures displayed in the Subaru Select Monitor to execute the following.
    1. When using a brake tester, depress the brake pedal with a force of 100 N (10.2 kgf, 22.5 lbf).
    2. When using a pressure gauge, press the brake pedal so that the pressure gauge indicates 3, 500 kPa (36 kgf/cm2 , 511 psi).
  3. The brake system being operated is displayed on the Subaru Select Monitor.
scientia non olet · About LEMON Manuals