LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Continuously Variable Transaxle (CVT) (H4DO)) >> Turbine Speed Sensor >> Installation

Turbine Speed Sensor: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.
  1. Install the turbine speed sensor.
    NOTE:
    • Use new O-rings.
    • Apply CVTF to the O-rings.

    Tightening torque: 

    7 N.m (0.7 kgf-m, 5.2 ft-lb) 

  2. Connect the harness connector.
  3. Lower the vehicle.
  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals