LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Continuously Variable Transaxle (CVT) (H4DO)) >> Transmission Control Module (TCM) >> Installation

Transmission Control Module (TCM): Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the TCM.

    Tightening torque: 

    7 N.m (0.7 kgf-m, 5.2 ft-lb) 

    Fig 1: Identifying Transfer Control Module
    G10275066Courtesy of SUBARU OF AMERICA, INC.
  2. Install the harness connector to TCM.
    NOTE: Move the lock lever in the arrow direction, and confirm that a clicking sound is heard.
    Fig 2: Moving Lock Lever
    G10275068Courtesy of SUBARU OF AMERICA, INC.
  3. Insert the transmission case cover (small) between transmission case cover (large) and transmission to install.
    NOTE: When inserting, be careful that the insulator inside transmission case cover is not turned over.

    Tightening torque: 

    7 N.m (0.7 kgf-m, 5.2 ft-lb) 

    Fig 3: Locating Transmission Case Cover Insulator
    G10274945Courtesy of SUBARU OF AMERICA, INC.
    Fig 4: Locating Transmission Case Cover Bolts
    G10274974Courtesy of SUBARU OF AMERICA, INC.
  4. Install the harness clip, and connect the following transmission radio ground terminal and transmission harness connector.

    Tightening torque: 

    13 N.m (1.3 kgf-m, 9.6 ft-lb) 

    Fig 5: Identifying Transmission Radio Ground Terminal And Harness Connector
    G10313069Courtesy of SUBARU OF AMERICA, INC.
  5. Install the air intake boot assembly. < Ref. to INSTALLATION , Air Intake Boot. >
  6. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  7. Perform the operation of AT learning mode. < Ref. to LEARNING CONTROL . >
scientia non olet · About LEMON Manuals