LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Continuously Variable Transaxle (CVT) (H4DO)) >> Secondary Speed Sensor >> Removal

Secondary Speed Sensor: Removal

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.
  • When secondary speed sensor is removed, CVTF leaks. After installing the secondary speed sensor, adjust the CVTF level.
  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Lift up the vehicle.
  3. Disconnect the harness connector from the secondary speed sensor.
  4. Remove the secondary speed sensor.
    Fig 1: Locating Secondary Speed Sensor
    G08317800Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals