LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Continuously Variable Transaxle (CVT) (H4DO)) >> Secondary Pressure Sensor >> Installation

Secondary Pressure Sensor: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
  • After installing the secondary pressure sensor, adjust the CVTF level.
  1. Install the secondary pressure sensor.
    NOTE:
    • Use new O-rings.
    • Apply CVTF to the O-rings.

    Tightening torque: 

    39 N.m (4.0 kgf-m, 28.8 ft-lb) 

  2. Connect the harness connector.
  3. Lower the vehicle.
  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  5. Refill CVTF to adjust the CVTF level. < Ref. to CVTF . >
scientia non olet · About LEMON Manuals