LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Seat System - Seats) >> Seat Heater System >> Installation >> Seat Heater Module - Front

Seat Heater Module - Front

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Affix the seat heater module - front to the pad assembly.
    CAUTION:
    • If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.
    • When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring.
    • When removing or replacing the seat cover, perform "Occupant Detection System Inspection" after installing the seat to check if the occupant detection system operates normally. < Ref. to SEAT , PRE-DELIVERY INSPECTION (PDI) PROCEDURE, Pre-delivery Inspection. >
    • If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part.
    • If the seat heater module is reused, remove the polyurethane section from the reverse side completely.

    Double-sided tape: 

    NITTO DENKO 501L or equivalent 

  2. Assemble the front seat. < Ref. to ASSEMBLY , Front Seat. >
  3. Install the front seat.

    Tightening torque: 

    53 N.m (5.4 kgf-m, 39.1 ft-lb) 

scientia non olet · About LEMON Manuals