LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Seat System - Seats) >> Front Seat >> Installation

Front Seat: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bring the front seat inside the vehicle.
    CAUTION: Be careful not to damage the body.
  2. Connect the connectors located under the front seat.
  3. Install the seat assembly.
    CAUTION: Tighten the slide rail assembly installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.
    Fig 1: Slide Rail Assembly Bolts Tightening Sequence
    G10272802Courtesy of SUBARU OF AMERICA, INC.

    Tightening torque: 

    Front seat assembly: 53 N.m (5.4 kgf-m, 39.1 ft-lb) 

  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  5. Install the headrest assembly - front.
scientia non olet · About LEMON Manuals