LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Power Rear Gate (Service Information)) >> Power Rear Gate Rod >> Removal

Power Rear Gate Rod: Removal

WARNING: This page is about a different car, the 2016 Subaru Outback, 2016 Subaru Legacy, 2015 Subaru Outback, and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Hold the rear gate to the fully open position.
  2. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  3. Release the claws and then remove the cap - rear quarter pillar UPR LH.
    Fig 1: Locating UPR Rear Quarter Pillar LH Claws
    G10309975Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the rod - power rear gate.
    CAUTION:
    • Using a small flat tip screwdriver wrapped with protective tape, remove the part by gradually applying force.
    • When the rod - power rear gate is removed, it could lead to abnormal play or noise. Therefore, always replace the stop ring with a new part. Also, be sure to check the clearance of the stop ring before installing. < Ref. to INSTALLATION , Power Rear Gate Rod. >
    1. Press down the rod - power rear gate to the ball stud (bracket rod - power rear gate).
    2. With the rod pressed, remove the stop ring while sliding along the ball housing groove.
      Fig 2: Disconnecting Power Rear Gate Rod From Ball Stud
      G10309976Courtesy of SUBARU OF AMERICA, INC.
    3. Disconnect the rod - power rear gate from the ball stud (bracket rod - power rear gate).
scientia non olet · About LEMON Manuals