LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Power Rear Gate (Service Information)) >> Power Rear Gate Inner Switch >> Removal

Power Rear Gate Inner Switch: Removal

WARNING: This page is about a different car, the 2016 Subaru Outback, 2016 Subaru Legacy, 2015 Subaru Outback, and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Remove the power rear gate inner switch.
    1. Release the claws and pull out the power rear gate inner switch rearward.
      NOTE: Insert a flat tip screwdriver wrapped with protective tape into the slit on the left.
    2. Disconnect the connector and remove the power rear gate inner switch.
      Fig 1: Locating Power Rear Gate Inner Switch
      G10309988Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals