LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Continuously Variable Transaxle (CVT) (H6DO)) >> Torque Converter Assembly >> Installation

Torque Converter Assembly: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the O-ring to front reduction drive gear.
    NOTE:
    • Use new O-rings.
    • Apply CVTF to the O-rings.
  2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.
    NOTE:
    • Apply CVTF to the oil seal lip.
    • Do not damage the oil seal and O-ring.
  3. Engage the splines while gently rotating the torque converter assembly by hand, and securely insert the assembly.
  4. Measure depth "A", from converter case end surface to drive plate contacting surface.

    Standard (reference): 

    6.8 mm (0.268 in) or less 

    Fig 1: Identifying Depth From Converter Case End To Drive Plate Contacting Surface
    G10276138Courtesy of SUBARU OF AMERICA, INC.
  5. Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >
scientia non olet · About LEMON Manuals