LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (Fuel Injection System (H6DO)) >> Throttle Body >> Installation

Throttle Body: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the throttle body to the intake manifold.
    NOTE: Use a new gasket.

    Tightening torque: 

    8 N.m (0.8 kgf-m, 5.9 ft-lb) 

  2. Connect the connector (A) to the throttle position sensor, and connect the preheater hose (B) to the throttle body.
    Fig 1: Locating Throttle Position Sensor Bolts
    G10263531Courtesy of SUBARU OF AMERICA, INC.
  3. Install the air intake boot. < Ref. to INSTALLATION , Air Intake Boot. >
  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  5. Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
  6. Install the collector cover.
scientia non olet · About LEMON Manuals