Engine Wiring Harness: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Set the engine wiring harness to the engine, and connect the connector.
NOTE:
- If the clip is damaged, replace it with a new part.
- Before replacing the clip, put an alignment mark (a) on both engine wiring harness and clip to remove the clip, and then align to the alignment mark (a) to attach a new clip to the engine wiring harness.
Fig 1: Identifying Engine Wiring Harness Alignment Mark
Courtesy of SUBARU OF AMERICA, INC.
- Structural diagram 1
  
  Fig 2: Engine Wiring Harness Structural Diagram 1
  Courtesy of SUBARU OF AMERICA, INC.
  
  Tightening torque: N.m (kgf-m, ft-lb)
  
  T: 19 (1.9, 14.0)
- Structural diagram 2
  
  Fig 3: Engine Wiring Harness Structural Diagram 2
  Courtesy of SUBARU OF AMERICA, INC.
Install the intake manifold assembly. < Ref. to INSTALLATION , Intake Manifold Assembly. >
Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >