LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Lighting System (Service Information)) >> Combination Switch (Light) >> Removal

Combination Switch (Light): Removal

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description. >
  1. Set the tire to the straight-ahead position.
  2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Repair Contents. >
  3. Remove the driver's airbag module. < Ref. to REMOVAL , Driver's Airbag Module. >
  4. Remove the steering wheel. < Ref. to REMOVAL , Steering Wheel. >
  5. Remove the cover assembly - column.
    1. Remove the clips, and remove the cover - column (a).
    2. Remove the screws.
    3. Release the claws, and remove the cover assembly - column UPR (b) and the cover assembly - column LWR (c).
      Fig 1: Removing Column Cover Assembly
      G10311282Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the steering roll connector. < Ref. to REMOVAL , Roll Connector. >
  7. Remove the switch assembly - combination wiper select. < Ref. to REMOVAL , Combination Switch (Wiper). >
  8. Remove the switch assembly - combination turn dimmer.
    1. Disconnect the connector.
    2. Using pliers, loosen the clamp.
    3. With the clamp loosened, release the claw using a flat tip screwdriver, and remove the switch assembly - combination turn dimmer.
      Fig 2: Removing Combination Turn Dimmer Switch Assembly
      G10270678Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals