LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Intake System (Induction) (H6DO)) >> Air Cleaner Case >> Installation

Air Cleaner Case: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the air cleaner case bracket to the vehicle.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  2. Install the air cleaner case (front) to the vehicle body and air cleaner case bracket.
    NOTE: Make sure that the protrusion of the air cleaner case (front) is inserted in the cushion of the air cleaner case bracket.

    Tightening torque: 

    6 N.m (0.6 kgf-m, 4.4 ft-lb) 

    Fig 1: Locating Air Cleaner Case Bolts
    G10263850Courtesy of SUBARU OF AMERICA, INC.
  3. Set the air cleaner case (rear) and air cleaner element to the air cleaner case (front). < Ref. to INSTALLATION , Air Cleaner Element. >
  4. Install the air intake duct. < Ref. to INSTALLATION , Air Intake Duct. >
  5. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals