LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Engine Cooling System (H4DO)) >> Active Grille Shutter >> Installation

Active Grille Shutter: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ambient sensor.
  2. Install the active grille shutter using the bolts securing the active grille shutter.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  3. Connect the connector to the active grille shutter actuator.
  4. Connect the connector to the ambient sensor.
  5. Install the front bumper. < Ref. to INSTALLATION , Front Bumper. >
  6. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  7. When the active grille shutter has been replaced, perform the calibration (execute the system operation check for ACTGS control). < Ref. to OPERATION , Active Test. >
scientia non olet · About LEMON Manuals