LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Air Bag System (Service Information)) >> Front Door Impact Sensor >> Installation

Front Door Impact Sensor: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • The front door impact sensor or connector is damaged.
    • Inner panel area of the panel assembly - front door is deformed.
    • Plate - door is deformed.
    • Side airbag module has been activated.
  2. Install the front door impact sensor.
    CAUTION:
    • Do not reuse the bolt and nut.

      Always replace with the specified new bolts and nuts.

    • Thoroughly clean the sensor mounting area before installing the front door impact sensor.
    • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  3. Install the sealing cover.
  4. Install the trim panel - front door.
  5. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals