Rear Brake Pad: Installation
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before installation, remove mud and foreign matter from the disc brake assembly.
- Install the pad - disc brake rear.
- Install the caliper body assembly.
Tightening torque:
Caliper bolt: 25 N.m (2.5 kgf-m, 18.4 ft-lb)
Brake hose bracket: 33 N.m (3.4 kgf-m, 24.3 ft-lb)
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
- Using the Subaru Select Monitor, exit the brake maintenance mode according to the display screen.
- After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally.
- Install the rear wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)