Sunroof Motor: Installation
CAUTION:
When installing the motor assembly - sunroof, be careful not to move the cable assembly.
- Install the motor assembly - sunroof.
- Install the light assembly - map.
- Connect the battery ground terminal. <Ref. to
BATTERY
, NOTE, Note.>NOTE: For models other than STI model, connect the ground terminal to battery sensor.
- Perform the initialize operation. <Ref. to INITIALIZE OPERATION , OPERATION, Sunroof Control System.>
- Check the operation of sunroof by following the table below.
Operation Switch position (1) Lid assembly - sunroof closes completely. Close (2) Lid assembly - sunroof is tilted up to the top position. Tilt up (3) Lid assembly - sunroof closes completely. Tilt down (4) Lid assembly - sunroof opens 295 mm (11.61 in) away from completely closed position. Open (5) Lid assembly - sunroof opens completely. Open (6) Lid assembly - sunroof closes completely. Close