LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Multi-function Display (MFD) >> Inspection >> Multi-Function Display Switch

Multi-Function Display Switch

  1. Measure the resistance between connector terminals.

    Preparation tool: 

    Circuit tester 

    Fig 1: Measuring Resistance Between Multi-Function Display Switch Connector Terminals
    G10270903Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Inspection conditions Standard
    2 - 3 (UP)
    ENTER
    (DOWN)    		 All OFF Approx. 1 MΩ or more
    2 - 3 (UP) ON Less than 1 Ω
    2 - 3 ENTER ON Approx. 1000 Ω
    2 - 3 (DOWN) ON Approx. 3670 Ω
  2. If the inspection result is not within the standard, replace the switch - multi-function display.
scientia non olet · About LEMON Manuals