Demonstration Screen Display
The demonstration screen can be displayed according to the following procedure.
CAUTION:
- While the ignition is OFF (ACC OFF), perform the steps described in 2 through 4 below within 10 seconds.
- To avoid battery discharge, perform the operation under the following condition.
- Perform the operation while the battery is being charged.
- While performing the operation and displaying the demonstration mode, do not operate any electrical parts.
- Sit in the driver's seat and close the door.
- Open the driver's door, and within 5 seconds, press the ENTER switch three times.
- Close the driver's door, and press the ENTER switch three times.
- Open the driver's door, and press the ENTER switch three times.
- Close the driver's door, and press the ENTER switch three times.
- Go to "Demonstration screen display".NOTE: The demonstration display will be cancelled in any of the following conditions.
- When 60 minutes elapsed since the demonstration mode started
- When the ignition is turned to ON
- When the ENTER switch is turned to ON for two seconds
- When the battery voltage is low