DTC U1135 Lost Communication With DCCD Control Module: Trouble Symptom

Coordination control of DCCD control module does not operate normally.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE .	Was the basic diagnostic procedure performed up to STEP 8?	Go to step 2 .	Perform the basic diagnostic procedure. <Ref. to BASIC DIAGNOSTIC PROCEDURE .>
2 CHECK DTC . Check the displayed DTC.	Are DTCs other than U*** displayed?	Perform the diagnosis according to DTC.	Go to step 3 .
3 CHECK DTC . Check the displayed DTC.	Is U1135 a current malfunction?	Go to step 4 .	Go to step 7 .
4 CHECK DTC . Using the Subaru Select Monitor, read DTC of all the systems.	Is the DCCD data reception error detected in several modules?	Replace the DCCD control module. <Ref. to DRIVER'S CONTROL CENTER DIFFERENTIAL CONTROL MODULE .>	Go to step 5 .
5 REPLACE MODULE . Replace the DCCD control module. Read the DTC using Subaru Select Monitor.	Is U1135 a current malfunction?	Go to step 6 .	System is normal.
6 CHECK MODULE . Reinstall the DCCD control module. Replace the module that the DTC has been detected. Read the DTC using Subaru Select Monitor.	Is U1135 a current malfunction?	Replace the DCCD control module. <Ref. to DRIVER'S CONTROL CENTER DIFFERENTIAL CONTROL MODULE .>	System is normal.
7 CHECK HARNESS . Shake the harness, and check for poor contact. Read the DTC using Subaru Select Monitor.	Is U1135 a current malfunction?	Repair the poor contact of harness, or replace the harness.	Go to step 8 .
8 CHECK CONNECTOR . Check the connector used for high speed CAN for poor contact.	Is there poor contact of connector?	Repair the connector that has poor contact, or replace harness.	It is possible that temporary poor communication occurs. Delete the DTC.