Steering Lock Control Module: Removal

CAUTION:

• Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
• Do not allow harness and connectors to interfere or get tangled up with other parts.
• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).>

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. <Ref. to BATTERY , NOTE, Note.>
   NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
2. Remove the column assembly - steering. <Ref. to REMOVAL , Steering Column.>
3. Remove the steering lock control module.
   1. Secure the column assembly - steering in a vise.
   2. Use the reverse tap or drill to remove the set bolt and remove the steering lock control module.

CAUTION: Do not apply any impact to the set bolt by a chisel or punch. Doing so may damage the control module.

Fig 1: Locating Steering Lock Control Module Set Bolt

Courtesy of SUBARU OF AMERICA, INC.