Section 5 (Engine Cooling System (H4DO)): Radiator: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: The radiator is pressurized when the engine and radiator are hot. Wait until engine and radiator cool down before working on the radiator.

Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Remove the air intake duct. <Ref. to REMOVAL , Air Intake Duct.>
Remove the front bumper. <Ref. to REMOVAL , Front Bumper.>
Remove the active grille shutter. <Ref. to REMOVAL , Active Grille Shutter.>
Remove the grille bracket.
NOTE: Remove six clips when removing the grille bracket.

Fig 1: Locating Grille Bracket Clips
Courtesy of SUBARU OF AMERICA, INC.
Drain engine coolant. <Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.>
Remove the front exhaust pipe. <Ref. to REMOVAL , Front Exhaust Pipe.>
Disconnect the radiator outlet hose from thermostat cover.

Fig 2: Locating Radiator Outlet Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Lower the vehicle.
Remove the reservoir tank. <Ref. to REMOVAL , Reservoir Tank.>
Disconnect the connector (A) from the radiator main fan motor and the connector (B) from the radiator sub fan motor.

Fig 3: Identifying Radiator Main Fan Motor Connector
Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Identifying Radiator Sub Fan Motor Connector
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the radiator inlet hose from the water pipe assembly.

Fig 5: Locating Radiator Inlet Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Remove the radiator upper brackets.

Fig 6: Locating Radiator Upper Brackets Bolts
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, remove the bolts securing the condenser lower bracket to the radiator.
ST 73099SG000 SPECIAL TOOL CONDENSER

Fig 7: Securing Condenser Lower Bracket To Radiator
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts securing the condenser lower bracket to the condenser, and remove the condenser lower bracket.
NOTE: This procedure is required to prevent the lower gasket from being damaged when removing the radiator.

Fig 8: Locating Condenser Lower Bracket Screws
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts securing the condenser upper bracket to the radiator.

Fig 9: Locating Condenser Upper Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Secure the condenser to the vehicle using ropes or other means.
NOTE: This procedure is required to prevent the condenser from dropping off and also damage to the air conditioner pipes.

Fig 10: Securing Condenser To Vehicle Using Ropes
Courtesy of SUBARU OF AMERICA, INC.
Lift the radiator up and away from vehicle.
Remove the radiator lower cushion from the vehicle body.

Fig 11: Locating Radiator Lower Cushion
Courtesy of SUBARU OF AMERICA, INC.