LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> Outback 2.5i >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Air Bag System (Service Information)) >> Front Sub Sensor >> Installation

Front Sub Sensor: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • If the airbag has been activated, replace the front sub sensor with a new part.
  • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts.
  • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • Front sub sensor or connector is damaged.
  2. Install the front sub sensor.

    Tightening torque: 

    13 N.m (1.3 kgf-m, 9.6 ft-lb) 

  3. Install the air intake duct. (When removing the sensor RH)
  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals